Skip to content

a blog on effects

Menu
  • Home
  • collection (486)
  • Ibanez (111)
  • Danelectro (53)
  • DOD, Digitech (51)
  • Electro-Harmonix (40)
  • Boss (54)
  • Other Brands (177)
Menu

Danelectro DSD-1 Shift Daddy

Posted on 15/04/2015 by mirosol

DSD1-ShiftDaddy

What is it?
Danelectro DSD-1 Shift Daddy Echo Pitch Shifter from original series of rocker pedals. Made in china around late 90’s.

I must admit that i was interested. And local music store happened to have one left behind. The unit had seen better days as it had sat in direct sunlight for years. Still unused, but with visible ageing and discolouring. The photo below may not seem much, but the flames should be in a lot deeper red. Otherwise the unit is in great shape.

DSD1-ShiftDaddy-1

Had to snap a shot of the tail lights too. Some dust around the edges, but nothing that a moist rag won’t fix.

DSD1-ShiftDaddy-2

What comes to the features of this unit, we have something not so common. Or that’s how it seems at first. Sticker with “this ain’t a wah” suggests that we are in for a treat. Sure there are a few Danelectro designs that are out there and this does apply to Shift Daddy as well. Echo Pitch Shifter. What comes to mind first is a weird digital effect with mashed up features borrowed from Boss pitch shifters and delays. But actually. No. Although some may consider these as valuable tools, and are amazed by the weirdness, i must disagree to some degree.

DSD1-ShiftDaddy-3

Why? Because once i fired this up, i knew exactly what it was all about. The rocker simply controls the delay time of a PT2399 chip. So in other words, this is nothing more but a quite standard delay design where the delay time setting has been moved to a pot controlled by foot. Rest of the pots (feedback and mix) are replaced with push button switches that look like exhaust pipes. So in fact, there’s nothing even resembling a real pitch shifting effect. Just basic delay unit.

DSD1-ShiftDaddy-4

There you have it. I had certain hopes for it, but those all got stumped when i played with the unit. And checked the insides. From the feature point of view, this is sadly the dullest one in all three rocker pedals ever made by Danelectro. You know, there are real tool like delay units that accept the use of external expression pedal for the delay time. Usually those are way better all digital designs too.

How does it sound?
Decent, but not much to write home about. It’s a delay. Nothing more. And it’s a digital PT2399 based delay, so do not expect anything else. It does what it does in a good way, but there just isn’t nothing special about it’s tone. The delay time range of the chip isn’t that great for this type of application. When the delay times goes from something like 40ms to 400ms, the sweep acts just way too fast and this makes it just plain annoying to use. It’s not a pitch shifter. Just a delay with time control on a rocker. And it doesn’t do even that feature extraordinary well. Disappointing, but there is still a bit of Danelectro magic in there. Not the worst, but not good. Proceed with caution.

2 thoughts on “Danelectro DSD-1 Shift Daddy”

  1. Garry Todd says:
    24/07/2018 at 16:47

    Question about this one: could this pedal be modified with a higher value pot in the rocker area to get more of a sweep? Or would that require a chip with more delay time?

    Reply
    1. mirosol says:
      24/07/2018 at 21:48

      Increasing the pot value will extend the maximum delay time, but with a notable drawback. With 50K pot, as used in most commercial PT2399 based pedals, the maximum delay time is somewhere around 550ms. This means that the internal frequency of the PT2399 will be a lot lower than recommended in the datasheet. This results is low bitrate and audible distortion. Datasheet recommends maximum value for the delay time pot as 27,6K – this results in 1% THD, which is still somewhat ok.

      So yes. Increasing the pot for 100K and up will give you more daly time. And no, this will result in glitches and considerable amount of distortion. Sure, you could up the pot for 500K (log taper should work better than linear), but then you’d end up with something that sounds close to Casper Electronics Echobender.

      Check these out:
      https://www.futurlec.com/Others/PT2399.shtml
      https://www.electrosmash.com/pt2399-analysis

      +m

      Reply

Leave a Reply to Garry Todd Cancel reply

Your email address will not be published. Required fields are marked *

/usr/bin/locate

/usr/bin/whoami

here used to be a short description of me. however, it wasn't exactly accurate anymore. so i'm replacing it with this placeholder for now. and yes. it's been a long time since my last post. but let me assure you. i'm very much still alive.

Found an error? One of my assumptions is dead wrong? Something else is just not right? Let me know! Leave a comment to a post, or drop a line to mirosol at kapsi dot fi.

I do mods, repairs and custom builds too. For inquiries, use the email address above.

/var/lib/collection

  • Electro-Harmonix (40)
  • DOD, Digitech (51)
  • Other Brands (177)
  • Boss (54)
  • Danelectro (53)
  • Ibanez (111)

/var/lib/tags

Amp Autowah Bass Boost Booster Chorus Compressor Delay Distortion Echo Envelope Filter EQ Filter Flanger Fuzz Harmony Loop Modulation Noise Gate Octave Overdrive Phaser Pitch Power Preamp Reverb Special/Multi Synthesizer Tremolo Tuner Utility Vibe Vibrato Wah

/usr/lib/comments_recent

  • zix on DOD FX55-B Supra Distortion
  • Ali Imran on Ibanez MF5 Modern Fusion
  • Ali Imran on Ibanez MF5 Modern Fusion
  • Schlunzo on Ibanez MS10 Metal Charger
  • Jefferson on Ibanez MS10 Metal Charger

/var/lib/archives

  • August 2016
  • July 2016
  • June 2016
  • September 2015
  • June 2015
  • May 2015
  • April 2015
  • March 2015
  • February 2015
  • January 2015
  • December 2014
  • November 2014
  • October 2014
  • September 2014
  • August 2014
  • July 2014
  • June 2014
  • May 2014
  • April 2014
  • March 2014
  • February 2014
  • January 2014
  • December 2013
  • November 2013
  • October 2013
  • September 2013
  • August 2013
  • July 2013
© 2025 | Powered by Superbs Personal Blog theme